The deduction you use most in Minesweeper is looking at just one number. You only look at two things.

  • How many covered squares without flags are around the number.
  • How many are left after subtracting the number of flags around it from the number.

Comparing these two settles the answer in the following two cases.

1. The Remaining Count Equals the Covered Squares: All Are Mines

123123221

Around the “2” at row 2, column 1, the only covered squares are row 1, column 1 and row 1, column 2. There are two mines, so both squares are mines.

On the edges and corners of a board, there are fewer squares around, so this shape turns up often. The easiest one is a “1” with only one covered square around it.

2. The Remaining Count Is 0: All Are Safe

Once the two mines in the diagram above are settled, place flags and look at the neighboring numbers again.

123123221

Around the “1” at row 2, column 3, there is one flag, at row 1, column 2. Subtract one flag from the number 1, and the remainder is 0. So the remaining covered square around it (row 1, column 3) is safe.

In the Minesweeper app, if you tap a number whose flags are complete, the rest of the squares around it open at once. When you spot this shape, you can move on just by tapping the number.

When There Are Flags, Think in “Remaining Count”

When there are flags around a number, think in terms of the “remaining count,” the number minus the flags.

123123232

Around the “3” at row 2, column 2, there is one flag (row 1, column 1) and two covered squares (row 1, column 2 and row 1, column 3). Subtract the one flag from 3 and the remainder is 2, and there are also two covered squares. So both squares are mines.

On the other hand, if the number of flags equals the number, the remainder is 0 and all the covered squares are safe.

123123121

There are two flags around the “2” at row 2, column 2, so the remainder is 0. Row 1, column 2 in the middle is safe.

When It Cannot Be Settled

When the remaining count is greater than 0 and smaller than the number of covered squares, one number alone cannot settle it. For example, a “1” with three covered squares around it does not tell you which one is the mine.

In that case, combine it with the neighboring number. How to compare two numbers is shown in diagrams in Minesweeper Patterns.

The App’s Deductions Start with This Shape Too

The Minesweeper app’s board building and “Hint” use three rules of deduction. The first is this “one number.” If no square can be settled by one number, it checks combining two numbers, and then the mines left on the whole board, in that order.

First, look around the edge of the board and start by finding these two shapes.